Protos-IP Protocol Scanner

Protos is an IP protocol scanner. It goes through all possible IP protocols and uses a negative scan to sort out unsupported protocols which should be reported by the target using ICMP protocol unreachable messages.

First Open Your backtrack and Follow these path
Applications->BackTrack -> Information Gathering -> Network Analysis -> Route Analysis -> protos


You can start it with./protos –I eth0 –d 192.168.1.2 (IP) -v


Usage: ./protos -i eth0 -d 10.1.2.3 -v
 -v                           verbose
 -V                          show which protocols are not supported
 -u                           don't ping targets first
 -s                           make the scan slow (for very remote devices)
 -L                           show the long protocol name and it's reference (RFC)
 -p x                       number of probes (default=5)
 -S x                        sleeptime is x (default=1)
 -a x                        continue scan afterwards for x seconds (default=3)
 -d dest destination (IP or IP/MASK)
 -i interface         the eth0 stuff
 -W                         don't scan, just print the protocol list

0 comments:

Post a Comment